| |
|
|
 |
|
|
| |
 |
Services
Customized products
We fabricate custom products of all kinds using the following materials: Carbon Steel,
Stainless Steel and Abrasion Resistant Steel.
We fabricate from specifications and drawings. Moreover, we are able to incorporate all
type of components (electrical, mechanical, hydraulic, etc.) during fabrication.
All projects are completely fabricated in our facilities from start to finish.
Non destructive testing
Can-Bec can carry out all non-destructive tests on welded joints.
We use the most advanced methods such as:
- Ultrasound
- Magnetic Resonance
- X-Ray
- Liquid Penetration
Stress relief
The use of stress relief is to eliminate the steel distortion caused
during fabrication. This is achieved by heat treatment of the finish parts.
Machining
Can-Bec Metal, being integrated into the Druco Machining Inc Group, offers full
machining services. It does not matter the level of machining required for your
project, from simple machining to complex parts, we are able to offer you the
highest quality service.
To familiarize yourself with our machining services we invite you to visit Druco
Machining web site at www.druco.ca
Surface preparation
Can-Bec Metal can offer different surface cleaning as per your specification requirements:
- Sandblasting
- Steel Grit
- Glass Beads
Surface finish
Can-Bec Metal uses on a regular basis a wide range of surface formulations.
We can offer from protective coatings, anti-rust coatings, powder coatings,
galvanize coatings, zinc coatings as well as epoxy coatings. These different
surface finishes will add years to your equipment.
Insulation, sound-proofing and rubber lining
We can offer you these services, at our plant, through subcontractors.
|
|
|
|
|
|
 |
|
